by LEGOM Technical Team | Nov 6, 2026 | HVAC, Underfloor Heating
Underfloor heating is efficient and comfortable when it works, and frustrating to diagnose when it does not, because most of the parts that might be at fault are out of sight. The pipes are buried in screed, the water is inside them, and the only components you can...
by LEGOM Technical Team | Oct 28, 2026 | Underfloor Heating
There is one number that governs almost everything in an underfloor heating system, and most explanations of how these systems work skip straight past it. A gas boiler delivers water at around 70 to 80 °C. An underfloor heating circuit needs water at roughly 35 to 45...
by LEGOM Technical Team | Oct 11, 2026 | Underfloor Heating
Zoning means dividing a heating system into areas that can be controlled independently. Each zone gets its own thermostat, and each responds only to what that part of the building actually needs. The appeal is obvious enough. You heat the rooms in use rather than the...
by LEGOM Technical Team | Oct 11, 2026 | Underfloor Heating
An underfloor heating system has three mechanical parts people think about and one electrical part almost nobody does. The pipe, the manifold and the heat source get specified carefully. The controls get wired by whoever is on site that day, and that is where a...
by LEGOM Technical Team | Sep 29, 2026 | Manifold, Underfloor Heating
Most manifold datasheets tell you the port count and the material, then stop. That leaves out the figures that actually decide whether a manifold fits the job: the centre distance between ports, the thread standard on the circuit connections, the pressure and...
by LEGOM Technical Team | Sep 25, 2026 | HVAC Valve, Underfloor Heating
Hotels, office towers, and apartment blocks rely on fan coil units to maintain comfort room by room. What determines whether each room actually holds its set temperature is a small component mounted on the FCU valve: the thermal actuator. This guide covers how thermal...